Creating a route with the ProNav Angler is as easy as pressing the screen and drawing your route. Check out the steps below for a full walk through:
- Position map where you would like to create your route
- Click the “Routes” button
- Start by pressing and holding to create a starting point
- Add additional points by pressing and holding your next location
- Start following your route by pressing “Go”
- Select “Start Route”
Notes:
- Adjusting Points
- After creating a route, press and hold on any point to drag it to a new location.
- Once a route is started you can adjust your points and save your changes, however, changes won’t take effect until the next time you start your route.
- Deleting Points
- Press the edit button (Looks like a pencil located in the top right of the screen)
- Short press a point and select “Remove Point” to remove it from your route
- Setting a New Start/End Point
- Short press any point and press “Set Start Point” or press “Set End Point”
- You can save your route prior to starting by clicking the save button in the top right corner